LOADING RIBBON 3
This chapter describes how to load a ribbon roll.
There are different ribbon requirements for the three types of
supplies:
Thermal Direct
Supplies
do not use a ribbon for printing.
Thermal Transfer
Supplies
require a ribbon for printing.
High Energy
Supplies
require a ribbon able to withstand high
temperatures.
High energy supplies are only available
for the 9830 printer.
If you are using thermal direct supplies, do not load a ribbon. If
you are using high energy supply, be sure to use a high energy
ribbon. See "Using a High Energy Ribbon" for more information.
If you want to use a high energy ribbon, you must send the supply
setup packet every time the printer is turned on.
Rev. C 3/99
Loading Ribbon 3-1
To Next Page
Loading...
