Potensi Elevator
10
/
13
Step 2: Press the knob to determine the key or function key 2 to enter the main interface of the
curve display, as shown in the figure:
Step 3: select the monitoring curve, the oscilloscope function can monitor the curve state of the
four variables at the same time, the debugger can choose different curves according to their
needs, or only one or several curves can be selected.
Press the multi-function key to set the curve of each channel, as shown in the following figure:
Step 4: The above figure reflects which curve corresponds to each channel, if you want to change
the curve of this channel, press the knob OK key, and the following figure dialog box appears:
Step 5: After specifying the curve, the corresponding channel will display the newly selected
curve, when all the channel curves are set, exit this interface.
Next press function key 1 to start drawing the curve. As shown in the following figure:
To Next Page
Loading...
