Potensi Elevator
9
/
13
Note: If it is the output terminal state, this interface only shows valid and invalid, and there is no
normally open and normally closed
When you directly press the modifier key, the function key 2, you can directly modify the
normally open and normally closed state of the corresponding terminal. Pressing the middle
knob key twice in a row can modify the function selection of the corresponding terminal
Curve display
The curve module provides an interface for debuggers to observe the trend of variables, the
curve module actually implements the function of a digital oscilloscope, and the curve module
provides two modes of operation, one is the real-time mode, which reads the information of the
variables at 50ms intervals and draws the curves sequentially according to the timeline. The
other is the cache mode, which can read the information of a variable in the all-in-one controller
at an interval of 2ms, which is convenient for debuggers to observe small changes in a certain
variable.
Step 1: Move the cursor to the position below screenshot shown on the main interface
To Next Page
Loading...
