Potensi Elevator
12
/
13
curve is drawn with a large amplitude, it has exceeded the upper edge of the display screen, the
operator will automatically adjust the amplitude of the curve.
4) A specific operation on a curve is only valid when the curve is stopped.
Summon status
The summon function simulates external and internal calls, summoning stairs on different floors.
Step 1: Move the cursor to the position below screenshot shown on the main interface
Step 2: Press the knob OK key or function key 1 to enter the main summoning interface
Step 3: As shown above, there is a moving box cursor in the middle, which is controlled by the
rotary knob and the knob determination key respectively, when the rotation rotates
When the button, the box cursor moves horizontally, when the knob is pressed to determine the
key, the box cursor moves vertically, the box is located at the intersection of the floor and the
summoning method, so that "_" means that there is no summoning, then press the function key
1, this position will become "■" for the summon, so "■", at this time press the middle knob key
represents the elimination sign. The location given in the figure can set the call information on
the 03rd floor.
Step 4: The summon function can summon the front and back doors, under this interface, press
the function key 2, it will switch to the back door, and then press it again to switch to the front
door, as shown in the figure:
To Next Page
Loading...
