SPEED ALERT
A speed limit can be set between 50~300kph.
Speed over the set limit will send an alert to your mobile phone.
MOVE ‘TOW’ ALERT
This is similar to geo-fence but is not at a fixed location – the location is where your vehicle is parked
when you activate ‘move’.
When stationary for more than 3 minutes, a ‘move’ command can be sent and sets a permitted
radius of travel of your choice (100m~5000m) from the parked location.
Movement outside this radius will send a text alert to your mobile phone.
If move alert is on, then geo-fence is automatically off.
POWER DISCONNECT ALERT
If the power to the tracker is disconnected, the tracker will send an alert.
FREQUENCY OF REPORTING – default 30 seconds
Set how often the tracker reports when moving or stationary with the engine running.
Typically, 30 seconds is used when moving as this gives a good map plot when history is viewed. 60
seconds is commonly used when not moving but the engine is still running (eg: traffic jams).
Set you own times to suit your requirements.
ENGINE IMMOBILISATION
(12volt relay supplied)
The tracker has the ability to immobilise the engine via the mobile APP or by a text message.
We highly recommend the installer only immobilises the starter motor.
By text, only the master paired phone can authorise immobilisation.
Any APP user can immobilise the engine as they have the confidential logon details.
PASSWORD FOR COMMANDS – does not affect your logon password.
The default password is 123456. This may be changed to any 6~8 digit number.
Must be digits (numerals).
Note: If changing the password, please make careful note of the new number.
SOS NUMBERS
Apart from the main ‘master’ user, you can add another mobile number that can receive alerts from
the tracker. Certain control commands can only be sent by the master user.
BATTERY BACK-UP
The GPS tracker has an internal battery which is charged once connected to your vehicle.
It provides 2~3 hours back-up in the event the vehicle battery is disconnected.
To Next Page
Loading...
