TESTING AN
ALARM ON
CYCLOOP
1. Leave your Key Fob at home.
2. Switch o Bluetooth on your phone and close the Monimoto Application.
3. Take your Cycloop-equipped bicycle for a test ride outdoors.
4. In approximately 1 minute you should receive a call from Cycloop and soon after
push notifications should arrive to the App.
5. Open the App and check whether it is showing the precise GPS, WLS based or
approximate Cell ID (LTE-M network based location).
6. If you received precise GPS locations – use one of the exit alarm mode methods
to disarm the alarm.
7. If you received an approximate location please re-install your Cycloop in a
dierent spot on your bicycle or try again. Note: very tall buildings can reduce
GPS signal strength to the point of not being able to obtain precise locations.
8. Repeat the test ride until you get precise GPS locations.
To Next Page
Loading...
