Adjustable Response Controls
Optimum imaging and set-up is established via pivoting tweeter,
pivoting IDC
®
driver module, high-frequency, midrange-frequency, and/
or boundary compensation controls (depending on model). The Boundary
Compensation control provides a gentle midrange roll-off response
while preserving the extreme low frequency output when the speaker is
placed close to a corner apex of the ceiling and wall.
Patented Tri-Grip
®
Fixing Clamps
The Tri-Grip
®
mounting clamps feature three clamping points per dogleg
providing triple the clamping surface area than conventional single-point
clamping speakers. Our wider three-point clamps provide a better seal
between the speaker and the ceiling maximizing bass response and
midrange clarity.
Easy Handling During Installation
All models feature protective crossover covers designed to prevent the
ingress of loose building materials and dust into the drivers and cross-
over. The protective covers also make handling easy, and protect the
crossover components from damage during installation.
Ready for Action in Humid Environments
All models will resist high humidity and ultraviolet light and can be placed
in bathrooms, pool areas, and outdoors.
New Construction Brackets
Accessory New Construction Brackets are available for all models to
help mark speaker placement during framing and prior to sheetrock
application. The brackets will span up to 24-inch stud spacing. New
Construction Brackets are not required for retrot applications.
Painting
A paint mask and additional grille scrim are provided for color matching
to any décor.
MMP
®
II
MMP
®
II (Metal Matrix Polymer) driver cones have a polypropylene base
loaded with metallic particles for a rigid and responsive structure. A
high-pressure, injection molded process achieves a different cone thick-
ness at critical points to optimize stiffness and consistency resulting in
superior sonic performance.
C-CAM
®
C-CAM
®
(Ceramic-Coated Aluminum Magnesium) is an innovative alloy
material originally developed by the aerospace industry for its use as
blades in jet engines where low mass and extreme rigidity are required.
Monitor Audio C-CAM
®
drivers are formed from an alloy of aluminum
and magnesium, which is made into the cone shape by a two stage high
pressure forming technique. After forming the shape, a layer of pure
ceramic (alumina) is depleted onto the surfaces, to give a completely
rigid exterior. The resulting properties of the C-CAM
®
material are
lightning-fast response for incredible clarity and extreme rigidity for low
distortion.
RST
®
The dimpled surface of C-CAM
®
drivers with the RST
®
(Rigid Surface
Technology) cone prole provides the conical shape of driver cones with
another degree of resistance to mechanical bending forces. The dimples
signicantly increase cone rigidity and allow us to use thinner and there-
fore lighter C-CAM
®
cones. The dimpled RST
®
pattern also displaces any
standing waves that can propagate across the cone surface. C-CAM
®
drivers with the RST
®
cone prole provide speed and accuracy, while
virtually eliminating distortion caused by cone-ex during operation.
Technology
100 Series
• •
200 Series
• •
300 Series
• • •
Technology at a glance
C-CAM Tweeter
MMP II Woofer
C-CAM Woofer
RST Technology
Features
Technology guide
monitoraudio.co.uk
To Next Page
Loading...
Need help?
General
