Monitor Audio airstream WS100 - UsingTheWs100; Cluster; GreenList

UsingtheWS100
After 30 minutes of continuous music playback the dongle will be automatically added to the receiver’s (speaker’s) Green List (see
below). The SKAA LED on the back will turn bright green to indicate this. The WS100 can store up to 4.
Alternatively, press the SKAA Button on the rear of the right hand speaker for 3 seconds, release it and the transmitter that is currently
being used will be added to the Green List.
If no audio is played for 150 seconds the USB dongle will go into power save mode and will stay in this state until audio playback is
resumed. The LED on the front will ash white and the SKAA LED on the rear will be faint amber or green. These indicators show that the
speakers are not bonded to a transmitter.
If no audio is played for 15 minutes, the whole system will go into stand by mode (red LED on the front) and will need to be turned on
again when playback is due to be resumed by pressing one of the volume buttons or the p button on the remote.
Cluster
A “Cluster” of WS100 receivers (speakers) can be created. When a cluster is created (please see the table below), the volume and SKAA
buttons will only work on the Master WS100 and this will control the volume and functions of all speakers within the Cluster.
Up to 4 pairs of WS100 can be used to create a cluster.
GreenList
The WS100 speaker (receiver) has the ability to store up to 4 dierent USB dongles (transmitters). This is a useful feature when owning
more than one USB dongle which can be purchased separately. The transmitters are stored in a “Green List” within the receiver. These
can be toggled, searched for, stored and deleted by pressing the “SKAA Button” on the rear of the right hand speaker. The functions and
SKAA LED indicator colours are listed in the table below.
3
Command Button Press
LED Indication
Hunt for Green List transmitters. Single Press = Hunting
(Flashing # times) = Green List #
= Bonded
Explore. Explores for new transmitters
not already on the Green List
Double Press = Hunting
= Bonded
Add or Delete a transmitter from the
green list
Hold (3 Seconds) to = Added
to (Single ash) = Deleted
The WS100 will automatically add a
transmitter after 30 minutes of music
playback.
- to = Added
Play/Pause. Repeat to cancel Triple Press or (Single ash) = Paused
Clears the Green List Six Presses (Flash) = Green list cleared
Create a “Cluster “ of speakers. You
can partner more than one pair of
speakers to a single USB transmitter.
The Master speaker will control the
others within the cluster.
Hold During Power On
1. Remove the dongle from the computer.
2. Power up the Master while holding
the SKAA button until the LED ashes
red.
3. Power on the remaining WS100’s.
4. Once the LED on the master
becomes solid, turn o the master
and then the others.
(Flash) = Master has entered Cluster
mode.
= Cluster has been successfully
created
Remove one or more WS100’s from a
Cluster.
Hold During Power On
1. Remove the dongle from the computer.
2. Power up the speaker you want
to remove from the cluster while
holding the SKAA Button.
3. Wait until the Red LED stops
ashing, power down the speaker
then turn it back on.