Monitor Audio All Weather In Ceiling Series User Manual

All Weather In Ceiling Series2
ENGLISH
1
Draw around template and mark centre lines if necessary.
Tri-Grip x 3
= 5Kgf/cm; 4.34 lbf/inch; 0.5 NM
88.5 mm (3
1/2
”)
211mm (8
1/4
”)
AWC265 & AWC265-T2
Template
Cut around marked line.
2
3
Connect speaker cables by pushing down on the
terminals and clamping the bare wire in the through
hole. Once connected close the protective cover.
5
Tighten the 3 Tri-Grip screws and replace the protective
screw covers.
See over tightening warning.
6
Fitting the All Weather In Ceiling Series Loudspeakers
4
Guide speaker into cut out.
Fit grilles. They are held in place magnetically and
should ‘snap’ into place.

Monitor Audio All Weather In Ceiling Series Specifications

General

Brand	Monitor Audio
Model	All Weather In Ceiling Series
Category	Speakers
Language	English