11
© Monitor Audio Ltd 2001
Speaker-level high pass filter
Monitor Audio’s subwoofers have a high pass filter. When your main/satellite
speakers are connected to the ‘speaker output’ terminals on the subwoofer, the low
bass frequencies below 100Hz are filtered from your main / satellite speakers.
This filter significantly reduces the bass demands placed on your main / satellite
speakers and can make a considerable improvement in their sound quality,
especially in the mid-bass and lower midrange. The filter may make subtle changes
to the sound quality, you may wish to experiment with or without the filter to
determine the best configuration for your system.
To use the filter, connect as speaker wiring option 1. See Fig 2.
If you have a Dolby Pro-Logic system, we recommend that you set the centre
channel switch on the processor to the normal mode. This provides a low bass filter
for the centre channel speaker and also insures that the bass from all three front
channels is fed to the subwoofer.
This high-pass filter does not operate when the subwoofer is connected using
interconnect cable (RCA phono).
To Next Page
Loading...
Need help?
General
