Monitor Audio Bronze W10 User Manual

5SPVCMF4IPPUJOH
Should you experience any technical, or set-up problems with your subwoofer please check the Trouble Shooting
guide below:
My subwoofer will not turn on/ no power.
q Is the LED illuminated on the top of the unit? If not, check your mains lead is properly connected both at the
TVCXPPGFSBOEBUUIFNBJOTPVUMFU"MTPDIFDLUIFGVTFPGUIFBNQMJˌFSBOENBJOTQMVHXIFSFˌUUFE
q Is the LED red? If so, you have power going to the unit. It could be that there is no signal, or the 12v trigger is
connected and the source not turned on (see below).
q Have you got the 12v trigger connected? If so, the subwoofer will not power up until the source is turned on.
q Is the unit receiving a signal (12v trigger not being used)? Is the Power Mode Switch in Auto or On position, and
signal source turned on? Try adjusting the volume level of the source.
*GJUTUJMMEPFTOPUUVSOPOQPXFSVQQMFBTFDPOUBDUZPVSMPDBMEFBMFSEJTUSJCVUPSPS.POJUPS"VEJPJNNFEJBUFMZ
No sound from subwoofer.
q Is the LED on the top red or green? If it is red, then the unit hasn’t actually turned on. See above suggestions. If
it is green, then your unit is powered up and turned on. Check further suggestions below.
q Are the signal leads connected correctly? Check these. If possible, check by replacing with a second, working
set.
q Is the volume level just very low? Try turning the volume on the source up a bit more.
q Have you tried switching input’s? If changing from LFE to Stereo (or vice versa), you need to power down the sub
XPPGFSˌSTU*UXJMMTUBZoMPDLFEpPOUPUIFJOQVUUIBUBDUJWBUFTJU
*GJUTUJMMEPFTOPUPVUQVUBTJHOBMQMFBTFDPOUBDUZPVSMPDBMEFBMFSEJTUSJCVUPSPS.POJUPS"VEJPJNNFEJBUFMZ
Bronze W106

Monitor Audio Bronze W10 Specifications

General

Brand	Monitor Audio
Model	Bronze W10
Category	Subwoofer
Language	English