Need help?Do you have a question about the Monitor Audio FB110 and is the answer not in the manual?
General| Type | Active Subwoofer |
|---|---|
| Weight | 15 kg |
| Lower Frequency Limit (-6dB) | 27 Hz |
| Input Impedance | 20k ohms |
| Driver Size | 10 inch |
| Drive Unit Complement | 1 x 10" long-throw driver |
| Low Pass Filter Alignment | Variable |
| Mains Input Voltage | 100 - 240 V~ 50/60 Hz |
| Inputs | Line-level RCA, LFE RCA |
| Outputs | Line-level RCA |
| Finish | Black |
| Amplifier Classification | Class AB |
Advice on running-in period for subwoofer drive units before optimum performance is achievable.
Procedure for returning equipment for warranty claims or service, including contact details.
Recommended settings for Gain, Frequency, Phase, and Mode for initial trials.
Covers reading manual, water, positioning, ventilation, heat, and power source safety.
Guidance on placing the subwoofer for optimal performance and ventilation.
Specific placement and usage guidelines to avoid for safe operation.
Identifies key controls and connection terminals on the subwoofer rear panel.
Explains the power switch operation and the function of the mode switch.
Details on adjusting gain, phase, and crossover frequency for optimal sound.
Describes RCA phono inputs/outputs and high level input/output connections.
Information on the mains fuse and the voltage selector switch.
Step-by-step guide for connecting the subwoofer using speaker cables.
How to connect main/satellite speakers directly to the subwoofer using high level outputs.
Explains the high pass filter's effect on main/satellite speakers and its use with Dolby Pro-Logic.
How to connect main/satellite speakers to the amplifier, not the subwoofer.
Instructions for connecting to pre-amplifier or surround sound processors via RCA inputs.
Steps for connecting the power and initial switch-on procedure.
Guidance on adjusting phase, gain, and frequency for optimal sound balance.
Checks for power, connections, and phasing when no sound is produced.
Solutions for excessive or inadequate bass, and vibrating noise issues.
Overview of technical specifications including frequency limits, amplifier output, and dimensions.
To Next Page