Pri
or
to
Fitt
in
g
the
Custom
In
st
all
S
eri
es
Sp
eaker
s
CAUTION: These Custom Install loudspeakers can only be fixed into plasterboaro (dry-lined) or suspended
ceilings/ walls with a thickness of up
to
45mm
(1
3
14
") . Solid wall installation will require channeling out and frame
work constructed
to
provide a structure for the
Tri
Grip®
dog legs
to
clamp
to
. For safety reasons, if you are unsure
of
your ability
to
provide a secure and safe fixing,
do
not attempt
to
fix these speakers, please obtain the services
of
a competent and qualified trades person.
CAUTION: Ensure that there are
no
water pipes or electricity cables running within the wall structure before cutting
the speaker apertures. Work from secure steps and avoid trailing wires.
Ove
r
lig
h
ten
ing
W
arni
ng
& ATTENTION INSTALLERS:
Do not over-tighten the Tri-Grip Dog Leg clamps. Over tightening the clamping mechanism on any
in
ceiling/
in
wall speaker
can result
in
damage
to
the speaker mounting hardware, ceiling/ wall or speaker frame,
and/
or
deflection
in
the speaker
frame during installation.
If you notice any
of
the above during installation, you have overtightened the
Tri
Grip dog leg. Back off the mounting screw
until deflection is reduced
to
allow the product
to
sit firmly against the ceiling I
wa
l
l.
& Do not exceed
5Kgf/cm
(4.34 lbf/inch.)
or
0.5
NM
when tightening
the
Tri
Grip dog leg screws.
When are using a cordless screwdriver/ drill to install this product ensure the clutch
is
set
to
it's lowest setting to avoid from
over-tightening and damaging the mounting hardware.
x®
Pa
i
nting
the
Grilles
& NOTE: If choosing
to
paint the grille, we recommend you follow these simple steps:
1.
Remove the membrane scrim from the inside of the grille.
2. Paint
all
grilles required for the installation with the same batch of paint
(if
they are
to
be the same colour). Spray paint
is
easier
to
apply or use a stippling action when brushing
to
avoid blocking the holes
of
the grille.
3. When
dry,
attach the spare membrane scrim (supplied) into the inside of the grille.
4.
Fit
the grille to the speaker
(s)
.
To Next Page
Loading...
Need help?
General
