Monitor M2400 - Component Assembly and Securing

Step 8: Install the Spill Tray
Place the spill tray on the floor where you plan to
locate your heater.
Remove the 2 sets of screws from the cabinet (Figure
16).
Position the heater on the spill tray so the legs of the
cabinet fit into the circular indentations in the spill
tray (Figure 16).
Retainers
Fig. 16
Legs Spill Tray
Step 9: Level the cabinet
In order for heater to operate properly. It must be
positioned on a level surface. Ensure proper leveling
by adjusting each leg and by using a carpenters level
to check both side to side, and front to back level
condition.
Attach and tighten both sets of retainers and screws.
Step 10: Install the Joint Pipe
At the rear of the heater, slide the large end opening
of the joint pipe into the exhaust port outlet of the
heater. Be sure the joint pipe is fully seated. Slide the
fabric cover over the joint pipe (Figure 17)
The o-rings that seal the joint pipe may be dry and tight.
A little soapy water will ease installation.
Fabric Cover
Joint Pipe
Fig. 17
Step 11: Connect the Heater to the Flue Pipe
Move the heater toward the wall, guiding the joint pipe
into the center port of the flue pipe (Figure 18).
Be sure the joint pipe is completely inserted into the
flue pipe.
Step 12: Install the Air Damper
If installation is standard (that is no extension kits are
required), place the air damper marked with a
"STANDARD" over the air intake flange on the flue
pipe (Figure 19).
Place the hose band around the end of the air supply
hose. Push the air supply hose onto the air intake
flange and secure the hose with the hose band.
NOTE:Do not place intake hose onto metal capped
exhaust port.
13