Monka mcHF - Page 20

F11 Display Settings F12 ON/OFF
Beacon
Ctrl+F/Alt+F save/load freq. HOME Back to 1500HZ
Ctrl+C call sign capture Ctrl+V ON/OFF voice rec
Ctrl+L Clear text area Ctrl+O ON/OFF
backlight
Ctrl+R: Switch Mark and Space on RTTY mode
N: Input name and callsign(TAB switch cursor)
S: Input serial number X: Input callsign and name
<CW> Rx：
W ：Word space C ：Dot and Dash space
B ： Bandwidth Z ：SKEW count
G： Threshold
<CW> Tx：
Encoder： Adjust WPM on CW transmission
Ctrl+Encoder： Adjust side tone freq Esc ：ON/OFF side
tone
note: N,S,X,B,W,C,Z use +/- or U/D to increase or decrease value。
<Time & Date>
ALT+D Set time CTRL+D Set date
Note: Backspace to delete first, and then enters according
to the original format, Ctrl + Z or ENTER to confirm.
<Macro>
*Fn Play Macro (End Key stops macro play )
Ctrl+*Fn Record Macro (Note： Max length 255 chars.)
Alt +*Fn Delete Macro
Symbols in Macro
Ctrl+S Insert TX ON symbol Ctrl+Q Insert Tx OFF symbol
Ctrl+M Record my callsign Alt +M Insert my callsign symbol.
Ctrl+T Record their call Alt +T Insert their call
N Record their call & name ALT+N Insert their name symbol
Note： Ctrl+Z or ENTER to confirm in marco recroding.
Cltr+backspace to empty, ESC to cancel。
<Cursor control>
Left: 1x: ← 2x: ↓ 5x: ALT + ← 10x: ALT
+ ↓
Right: 1x: → 2x: ↑ 5x: ALT + → 10x: ALT +
↑
第 20 页