11
ZISW42DY (white dispenser)
ZISB42DY (black dispenser)
42" Built-In Refrigerator
Standard Trim with 1/4" Panels
• 1/4" Panels: Cut panels to size.
• Custom handles with 1/4" door panels require Trim Kit
ZKH1. When using ZKH1 with the standard dispenser
trim, the length of the custom handle, top to bottom
cannot exceed 11-3/4".
• Custom collar dispenser trim with 1/4" door panels
require trim kit ZWCD1.
Standard Trim with Panels secured to
1/4" thick backing
• Applying a raised panel design to a 1/4" thick backing
(screwed or glued): Cut 1/4" panels to size, fabricate
the raised panel to permit clearances of at least 2"
from the handle side for fingertip clearance, 1-1/4"
from the hinge side to avoid striking adjacent
cabinetry and 5/16" from the top and bottom edges to
allow for the trim flange, then install.
• Countertops adjacent to refrigerator installation
should be mitered 45° degrees.
Note:
ZWCD1 custom collar dispenser trim and ZKHT1
custom handle kits cannot be used in this configuration.
Custom Door Panel Dimensions Using Standard Trim
1/4" thick panels
or
Panels secured to 1/4" thick backing
1 1/4"
Clearance
hinge side
2" Clearance
handle side
Appearance
Panel
1/4"
Thick
Backing
Raised Panel on 1/4" Thick Backing
Door
Handle
Case Trim
41"
9"
1/4" Thick Panel
Custom Grille Panel
The grille panel frame is factory assembled
for 84" installation height. If installation height
varies, order ZG1 trim kit which provides
optional side trim pieces. Cut custom, Lexan
or stainless panel to sizes shown below.
Installation Height Panel Height
83" 8"
83-1/2" 8-1/2"
84-1/2" 9-1/2"
Important:
Maintain 1-1/2" min. gap between
top of doors and bottom of panel frame.
9 7/16"
12 5/16"
The Cutout is 9 7/16" wide
by 12 5/16" high.
Custom Dispenser Cutout
16 5/8"
36 7/8"
2 9/16"
67 7/8"
15 1/4"
15 1/4"
25 1/4"
17 11/16"
Fresh Food Panel
Freezer Panel
Standard
Dispenser
Freezer Panel
Custom
Dispenser
Monogram
Dimensions &
Specifications
CUSTOM PANEL
DIMENSIONS
To Next Page
Loading...
