26
First use
First use
Checking the laminator and package contents
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a
sharp knife or other pointy object, you may quickly damage the
laminator.
− Therefore, be very careful when opening the packaging.
1. Take the laminator out of the packaging.
2. Check whether the laminator or the individual parts exhibit damage. If this is the
case, do not use the laminator. Contact the manufacturer at the service address
specied on the warranty card.
3. Check to make sure that the delivery is complete
Setting up the laminator
1. Position the laminator so that there is enough space to insert a laminating
pouch. Do not position the laminator directly in front of a wall or other
objects.
2.
Connect the mains plug to a properly installed socket with a protective conductor
(AC 220–240 V / 50 Hz = house connection).
Activating / deactivating the laminator
1. Move the ON / OFF switch
3
to ON to switch the laminator on.
The ready indicator
1
will turn from dark blue to red once the laminator
has reached the correct temperature for lamination.
The preheating time may vary depending on the ambient
temperature and air humidity.
2. Move the ON / OFF switch to OFF to switch the laminator o.
To Next Page
Loading...