09
EN
Power supply management system
Remarks: All technical specifications in this manual and external packages are
subject to change without further notice. In case that there is subtle difference
between this manual and practical operation, please follow practical operation.
1. Push up the slider near the base VESA cover;
2. Rotate the entire base counterclockwise upwards;
3. Tilt the base aut in the direction of the arrow;
4. Unscrew the 3 M4 *16 screws of the base and pull out the base in the
direction of the arrow.
Instruction of Base Installation
To Next Page
Loading...
Need help?
General
