your waste
equipment
for
recycling, please
contact your
local
city office, your
household waste
disposal service, or the store from which you purchased
the
product.
For
more information
about
Monster products,
please
visit
us
at:
www.MonsterProducts.com.
FCC
10:
RJE-191011
This device
complies
with
Part
15
of
FCC
Rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
This device may
not
cause
harmful
interference,
and
(2)
This
device must accept any interference received,
including
interference
that
may cause undesired operation.
Changes
or
modification
not
expressly
approved by the party
responsible
for
Compliance could
void
the
user's
authority
to
operate the equipment.
Connecting
of
peripherals
requires the
use
of
grounded
shielded signal cables. The
socket-outlet shall
be installed
near the
equipment
and
shall
be easily accessible.
Note: This
equipment
has
been tested
and found
to
comply
with
the
limits
for a
Class
B
digital
device, pursuant
to
Part
1 5
of
the
FCC
Rules.
These
limits
are designed
to
provide
reasonable
protection
against
harmful
interference in a
residential installation. This equipment
generates,
uses
and
can
radiate radio frequency energy and,
if
not
installed
and used in accordance
with
the instructions, may cause harmful
interference
to
radio communications. However, there
is
no guarantee
that
interference
will
not
occur in a
particular installation.
If
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception, which can be determined by
turning the
equipment
off
and on, the user
is
encouraged
to
try
to
correct the
interference by one
or
more
of
the
following
measures:
•
Reorient or
relocate
the
receiving antenna.
• Increase
the
separation between the
equipment
and receiver.
• Connect the
equipment
into
an
outlet
on a circuit different from
that
to
which
the
receiver
is
connected.
• Consult
the dealer
or
an
experienced radio/TV technician for
help.
Caution
Changes
or
modifications
not
expressly
approved by the
party
responsible
for
compliance could
void the user's (or your) authority
to
operate the equipment.
Avoid storage in extreme heat
or
cold.
Avoid exposure
to
liquids,
temperature
extremes and high
humidity
. The product's working temperature range
is
0-45°C
(32-113°F).
Industry
Canada
This
device
complies
with
Industry Canada license-exempt
RSS
standard(s).
Operation
is
subject
to
the
following
two
conditions:
(1)
this device may
not
cause
interference, and
(2)
this device must accept any interference, including
interference
that
may cause undesired operation
of
the device. Under
Industry
Canada
regulations,
this radio transmitter may
only operate using
an
antenna
of
a type and maximum (or
lesser)
gain approved for
the
transmitter by
Industry
Canada.
To
reduce
potential
radio interference
to
other
users,
the
antenna type
and its gain
should
be
so
chosen that the
equivalent isotropically
radiated power
(e.i.r.p.)
is
not
more than
that
necessary for
successful
communication.
To Next Page
Loading...
