To Next PageTo Next PageWhat to do if the main burner of my Montigo Indoor Fireplace will not light?
If the main burner of your Montigo Indoor Fireplace won't light, first check the wiring as shown in figure 25. Ensure the wall switch has a proper connection. Also, inspect the pilot burner; if it's out, let the fireplace cool down before attempting to relight it. If the issue continues, it is recommended to call a qualified service person.
How to fix a noisy pilot flame on a Montigo Indoor Fireplace?
To address a noisy pilot flame in your Montigo Indoor Fireplace: first, locate the pilot adjustment screw on the front of the gas control valve. Decrease the flame by turning the adjustment screw clockwise. If the problem persists, allow the fireplace to cool completely, then try relighting it.
General| Type | Direct Vent |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Vent Type | Direct Vent |
| Ignition | Electronic Ignition |
| Burner Material | Stainless Steel |
| Warranty | Limited Lifetime Warranty |
| Control Type | Remote Control |
| BTU Input (LP) | 40, 000 BTU |
| Venting | Direct Vent (Horizontal or Vertical) |
| Firebox Dimensions (W x D x H) | 24" H |
| Heat Output | 40, 000 BTU/h |
| BTU Input (NG) | 40, 000 BTU/h |
Procedure for connecting the gas supply line to the fireplace unit.
Covers direct venting installation requirements and component selection.
Details on venting requirements, including horizontal and vertical run limits for rear venting.
A graph used to determine acceptable vent runs based on vertical height and horizontal run.
Details on venting requirements for top vent installations, including use of vent graph.
Graph to determine acceptable vent runs for top vent installations based on vertical rise and run.
Diagram and instructions for wiring the gas control, pilot assembly, and fan.
How to adjust the flame height using the Hi-Lo adjustment knob on the gas control valve.
Essential safety precautions and warnings to follow before attempting to light the fireplace.
Immediate actions to take if a gas leak is detected, emphasizing safety and contacting authorities.
Step-by-step guide on how to safely light the fireplace pilot and burner.
Procedure for safely turning off the gas supply to the appliance.
Essential safety precautions and warnings for lighting the fireplace with an intermittent pilot system.
Immediate actions if gas is detected, emphasizing safety and contacting authorities for intermittent pilot models.
Step-by-step guide for lighting the fireplace with an automatic ignition system.
Procedure for safely shutting off the gas supply to the appliance for intermittent pilot models.
Covers annual inspections, gas pressure requirements, and keeping the area clear.
A chart listing common problems and their corrective actions for the M40DV-PFC model.
A flowchart sequence for troubleshooting the Honeywell ignition control system.
Details on the M40DV-PFC-MH model for mobile homes, including ratings and approvals.
