montpellier MON-MW7012P

Questions and Answers

D
Daniel DavisAug 15, 2025
Why is the spinning operation not working on my montpellier MON-MW7012P?
- J
  Joshua MendozaAug 15, 2025
  If the spinning operation in your Montpellier Washer is not performed or runs late, it may be because the out of balance load control system has been activated. The out of balance load control system will try to spread your laundry correctly, and the spinning operation will begin after your laundry is spread. Place the laundry in the machine in a balanced fashion next time.
Y
yyoungAug 18, 2025
How to fix a montpellier MON-MW7012P that won't start?
- J
  Jason ClarkAug 19, 2025
  If your Montpellier Washer doesn't start, several factors could be at play. Ensure the appliance is properly plugged in and that the fuse hasn't blown; replace the fuses if needed. Check that there isn't an electricity cut-off. Make sure you've pressed the Start/Pause button and that the program dial isn't set to the ‘stop’ position. Finally, ensure the machine door is completely closed.
S
Steven AllisonAug 22, 2025
What to do if my montpellier MON-MW7012P Washer isn't taking in water?
- P
  Pamela ThomasAug 22, 2025
  If your Montpellier Washer isn't taking in water, start by checking if the water tap is turned on. Inspect the water inlet hose for any twists and untwist it. Also, the water inlet hose or the valve inlet filter might be clogged, so clean these filters. Ensure that the machine door is completely closed.
C
Chase GregoryAug 25, 2025
Why is my montpellier MON-MW7012P not discharging water?
- T
  Thomas LongAug 25, 2025
  If your Montpellier Washer isn't discharging water, the outlet hose might be clogged or twisted; inspect and clean or untwist it. Another potential cause is a clogged pump filter, so clean the pump filter. Also, if laundry is settled unevenly, spread your laundry in the machine evenly.
A
anna59Aug 28, 2025
How to stop my Montpellier Washer from vibrating?
- S
  Stephen JacksonAug 28, 2025
  If your Montpellier Washer is vibrating, it might be due to several reasons. First, ensure the feet of your machine have been adjusted correctly and that it is level. Check that the transit bolts fitted for transportation have been disassembled. Note that a smaller amount of laundry will not stop operation of the machine. If the machine is overloaded or laundry is settled unevenly, do not put in more laundry than the recommended amount and settle it evenly.
J
Jessica BryanAug 30, 2025
Why is my montpellier MON-MW7012P Washer not washing clothes properly?
- K
  Katrina PalmerAug 30, 2025
  If you're getting unsatisfactory washing results from your Montpellier Washer, consider whether the program you've chosen is appropriate for the soiling of your laundry. Also, ensure you are using a sufficient amount of detergent based on the amount and contamination degree of your laundry. Finally, make sure you have not exceeded the maximum laundry capacity of your machine. Load your machine with an amount of laundry which will not exceed the maximum laundry capacity.
J
James JonesSep 2, 2025
How to reduce excessive foam in my montpellier MON-MW7012P detergent drawer?
- F
  Faith MillerSep 2, 2025
  If excessive foam is forming in the detergent drawer of your Montpellier Washer, it may be due to using an excessive amount of detergent or using the wrong detergent. To eliminate foam formation, press on the start/pause button, mix a spoon of softener with half a litre of water, and pour the mixture into the detergent drawer. After 5-10 minutes, press the start/pause button again. In your next wash, adjust the detergent dose accordingly. Use detergents produced only for automatic washing machines in your machine.
M
Mary ReeseSep 5, 2025
Why does my laundry have detergent residues after washing in my montpellier MON-MW7012P Washer?
- T
  Thomas BrownSep 5, 2025
  If your laundry has detergent residues after washing in your Montpellier Washer, it could be that non-dissolving particles of some detergents are sticking to your laundry as white spots. Perform an extra rinsing by setting your machine to “Rinsing” program, or clean the spots with a brush once dry.
M
Michael SanchezSep 8, 2025
What to do if my Montpellier Washer discharges water immediately after loading?
- J
  Janice PerezSep 8, 2025
  If water discharges from your Montpellier Washer as soon as it's loaded, the end of the water outlet hose may be too low. Set the water outlet hose at appropriate height.
E
Elizabeth PetersonSep 12, 2025
Why are there grey spots on my laundry after using my montpellier MON-MW7012P?
- D
  dawnmooreSep 12, 2025
  If grey spots appear on your laundry after washing in your Montpellier Washer, the reason for such spots may be oil, cream or ointment. Apply the maximum amount of detergent instructed by the detergent manufacturer in the next washing operation.