Child lock function
Press and hold the TIMER button on the upper control panel for 3 seconds, the heater is locked
and can no longer be operated, the lock symbol lights up. Press the TIMER button again for 3
seconds to disable the child lock.
Setting the room temperature
The temperature range is 15-35°C, the default setting is 30°C.
Press the TEMP button to set the desired temperature (in 1°C increments).
In this mode, the “TEMP” and “Mode” buttons light up and the heater switches on and off
automatically to maintain the set temperature.
Mood lights
There are three mood lights fitted to the top panel:
blue for fan mode, purple for medium heating power, red for high heating power and ECO mode;
these can be turned off via the remote control.
ECO mode: The red mood light goes into flow mode and the ECO icon lights up. The heater heats
using a high heat/low heat cycle, to maintain room temperature at 24°. The heater switches off
automatically if the operating mode isn’t refreshed within 24 hours.
Oscillation
Press the OSC button to allow movement from side to side (60°) for a better distribution of airflow.
Press it again to deactivate the function.
Night mode
Press and hold the button for 3 seconds to turn off the LED display and press any button to
turn it back on.
3. Press the , button to switch off the heater. The fan will continue to run for 15 seconds to
allow the unit to cool down.
Overheating protection
The heater is fitted with overheating protection, which automatically turns off the unit when it
overheats, e.g. if the ventilation grilles become completely or partially blocked. Should this happen,
unplug the mains plug from the socket, wait approx. 30 minutes until the appliance has cooled
down and remove the object blocking the ventilation grille. Then switch the heater back on as
described above. The heater should now work normally again. If the problem persists, please
contact our customer service team.
Note: Do not touch or cover the air outlet while the heater is in use. This can cause the unit to
overheat and trigger the safety mechanism.
Note: To protect the internal components from overheating, the fan will continue to run for 15
seconds after the OFF button is pressed before switching to standby mode.
Tip-over shutoff
The heater is also equipped with a tip-over shutoff mechanism that automatically cuts off the
power supply if the heater tips over or is tilted.
7.0 MAINTENANCE AND CARE INSTRUCTIONS
Always switch off the appliance and disconnect the mains plug before carrying out maintenance
or inspection work.