Moog Mother-32 Quick Start Guide

PRESET: EVERYTHING!
NOTES:
A Patch which uses the envelope-controlled audio-rate LFO as a bass
drum, and the noise generator as a snare drum. The keyboard voltage
controls the VC MIX between them, and the ACCENT trigger voltage
controls the MIX between the VC MIX drum bus output and the VCO
melodic output. The ASSIGN jack must be set to output ACCENT
voltage in order for this patch to work properly.
When sequencing this patch:
- The lowest note of OCTAVE 1 will cause only the bass drum to sound
when ACCENT is on for that step.
- Any note in OCTAVE 2 or OCTAVE 3 will cause the bass drum to
sound along with a bass tone when ACCENT is on for that step.
- The highest note of OCTAVE 8 will cause only the snare drum to
sound when ACCENT is on for that step.
- Any note in OCTAVE 2 through OCTAVE 6 will function normally when
ACCENT is off for that step.
PATCHING:
EG > LFO RATE
LFO TRI > MIX 1
NOISE > MIX 2
KB > MIX CTRL
VC MIX > EXT. AUDIO
ASSIGN > MIX CV

Moog Mother-32 Specifications

General

Type	Semi-modular analog synthesizer
Envelopes	ADSR envelope generator
Oscillator	1 x VCO with pulse and sawtooth waveforms
Filter	20Hz-20kHz Moog Ladder Filter with resonance
LFO	Low-frequency oscillator with triangle and square waveforms
Sequencer	32-step sequencer
Patch Points	32 x 3.5mm patch points
Power	12V DC power supply
MIDI	MIDI input