MOONEY
M20TN
SECTION IV
NORMAL PROCEDURES
4--18
AIRPLANE FLIGHT MANUAL
ORIGINAL ISSUE -- 12--22--2006
NOTE:
Landing information for reduced flap settings is not available. See SECTION V for
Landing Distance tables.
NOTE:
If maximum performance landings are desired, use above procedures except, re-
duce approach airspeed to 70 KIAS (flaps full down) and apply maximum braking
(without skidding tires) during rollout.
NOTE:
Crosswind landings should be accomplished by using above procedures except
maintain approach speed appropriate for wind conditions. A llow aircraft to crab
until the landing flare. Accomplish touchdown in a slight wing low sideslip (low
wing into wind) and aircraft aligned with runway. During landing roll, position
flight controls to counteract crosswind.
-- C A U T I O N --
Landing gear may retract during landing roll if landing gear switch is placed in
the UP position.
TAXI AFTER LANDING
Throttle AS REQUIRED...........................................................
Fuel Boost Pump Switches OFF....................................................
Wing Flaps RETRACT............................................................
Elevator Trim TAKEOFF SETTING..................................................
Avionics/Radios AS REQUIRED....................................................
Interior/Exterior Lights AS DESIRED.................................................
SHUTDOWN
Parking Brake SET................................................................
Throttle IDLE 900 RPM............................................................
Interior/Exterior Lights OFF.........................................................
Pitot Heat OFF...................................................................
Magneto/Starter Switch GROUNDING CHECK.......................................
Mixture IDLE Cut--OFF............................................................
Alternator Field Switch OFF........................................................
Master Switch OFF................................................................
Magneto/Starter Switch OFF.......................................................
-- C A U T I O N --
Allow the engine to idle at 900 RPM for 5 minutes before shutdown in order to
cool the turbochargers. Taxi time can be counted as cooling time.
SECURING AIRCRAFT
Magneto/Starter Switch VERIFY OFF/key removed...................................
Master Switch VERIFY OFF........................................................
Electrical Switches VERIFY OFF...................................................
Interior Light Switches VERIFY OFF................................................
Emergency Bus Switch VERIFY OFF................................................
Parking Brake RELEASE – Install wheel chocks.......................................
Extended Parking Control Wheel Secured...........................................
Cabin Windows and Doors Closed and Locked.......................................
TIE DOWN AIRCRAFT
at wing and tail points
Refer to GROUND HANDLING - POH Section VIII for proper procedure
To Next Page
