Morbella TX1 - Motion Detector

26
© 2017 Ma k a T e c hnologie s G roup . A ll Righ ts Re s er v ed .
Getting Started
Operation of your TX1 F HD Digital Roadcorder
TM
5 Press on the Up or Down button to make your selection
6 Press on OK to confirm your entry and exit to setting
7 Press on button twice t o exit Setting and back recording mode
8 Start recording by pressing OK button
9 Stop recording by pressing OK button again
M o t ion Detect o r
This function enables you to use your device as a remote surveillance camera
with motion detection functionality. It uses the built-in camera to detect
movements in the surrounding area using an advanced motion detection
algorithm. Camera will auto record If it detects any movement.
1 Press OK to stop recording.
2. Press once to enter into video setting
3 Press on Up or Down button to navigate to the function that shows
Motion Detection
4 Press on OK to enter and show : OFF/ ON
5 Press on the Up or Down button to make your selection
6 Press on OK to confirm your entry and exit to setting
7 Press on button twice t o exit Setting and back recording mode
8 Start recording by pressing OK button
9 Stop recording by pressing OK button again