Morbella TX1 - Date; Time; Car no Stamp

29
© 2017 Ma k a T e c hnologie s G roup . A ll Righ ts Re s er v ed .
Getting Started
Operation of your TX1 F HD Digital Roadcorder
TM
Date/ Time Setup
Access the following settings to change the device’s time and date.
If the battery remains fully discharged or removed from the device, the
time and date is reset.
1 Press OK to stop recording.
2. Press once to enter into video setting
3 Press on Up or Down button to navigate to the function that shows
Date / Time
4 Press on OK to enter and see in : YY/MM/DD
5 Press on the Up or Down button to make your selection
6 Press on OK to confirm and next entry made follow by exit setting and
back to recording mode
7 Start recording by pressing OK button
8 Stop recording by pressing OK button again
Car No Stamp
This function enable you to enter car plate number of your own vehicle for video
recording information.
1 Press OK to stop recording.
2. Press once to enter into video setting
3 Press on Up or Down button to navigate to the function that shows
Car No Stamp
4 Press on OK to enter and show : Off / On
5 Press on the Up or Down button to make your selection