To Next PageTo Next Page
Need help?Do you have a question about the Morco FEB24ED3* and is the answer not in the manual?
General| Model | FEB24ED3* |
|---|---|
| Boiler Type | Condensing |
| Mounting | Wall Mounted |
| Output | 24 kW |
| Central Heating Output | 24 kW |
| Fuel Type | Gas |
| Gas Type | Natural Gas |
| Ignition | Electronic |
| Weight | 32 kg |
| Type | Combi |
| Dimensions | 700 x 400 x 280 mm (H x W x D) |
Legal requirement for gas appliance installation by registered person for safety.
Overview of the MORCO FEB-24ED 3 as a combination boiler.
Instructions for operating the boiler for domestic hot water.
Instructions for operating the boiler for both hot water and central heating.
Guide to setting time and on/off times on the programmable clock.
Explanation of red light indicating lockout and how to reset.
Instructions on how to safely turn off the boiler.
Notes on factors affecting hot water temperature and delivery.
Details on boiler's safety lockout feature and reset procedure.
Explanation of the boiler's frost protection feature.
Description of the anti-pump seizure device function.
Information on the pressure gauge and its expected readings.
Recommendation for regular servicing by a qualified engineer.
General safety instructions regarding flue obstruction and faults.
Steps to prevent freezing during winter storage.
Clarification on the limitations of the frost protection feature.
Overview of the boiler's type, output, and suitability.
Features of electronic controls, including temperature selection and safety functions.
Schematic diagram of the boiler's hydraulic circuit.
Detailed technical specifications of the boiler.
Diagrams and dimensions for boiler installation and connections.
User recommendations for gas safety and proper installation.
Guidelines for selecting an appropriate location for the boiler.
Requirements for correct positioning of the flue terminal.
Specifications for minimum clearances around the boiler.
Guidance on ventilation requirements for boiler installation.
Requirements for electrical supply and plug connection.
Details on required propane gas supply and connection.
General info on connecting to sealed central heating water systems.
Specific requirements for sealed central heating water systems.
Information on the expansion vessel and when an additional one is needed.
Details on the pressure relief valve and its discharge pipe.
Requirements for Domestic Hot Water (DHW) system connections and pressure.
Information on how boilers are packaged.
Instructions and diagrams for mounting the boiler on the wall.
Guidance on electrical wiring, including safety and thermostat connections.
Information on connecting and installing an external room thermostat.
Instructions for connecting water and gas pipes to the boiler.
Details on approved air/flue systems and installation requirements.
Procedure for purging and testing the gas circuit for leaks.
Information on factory pre-set boiler settings.
Steps for initial start-up and operation of the boiler.
How to operate the boiler for domestic hot water.
How to operate the boiler for both heating and hot water.
Procedure for safely turning off the boiler.
How to reset the boiler after a safety lockout.
Final checks after commissioning, including gas soundness and settings.
Installer's responsibilities when handing over to the user.
Recommendations for regular servicing by a qualified engineer.
Minimum clearances needed for maintenance access.
Instructions for removing the boiler's front cover for access.
Instructions for cleaning the boiler's fan.
How to inspect and clean the burner and heat exchanger.
Checking the condition of ignition and detection electrodes.
Inspecting the boiler's pipework for leaks and pressure.
List of common issues encountered with the boiler.
How to check and set the burner pressure.
Performing final checks after installation or servicing.
Explanation of fault codes displayed by the boiler.
A table listing fault codes and their meanings.
Terms and conditions of the boiler's warranty.
