Morgan Olson C250 - Page 11

Page 21
Page 20
1. Hold the latch and pull the seat belt across body. Do not
twist the webbing.
2. Insert the seatbelt tongue into the buckle until you hear a
snap and feel it latch.
3. Press the button to release the seatbelt.
FASTENING & UNFASTENING
THE SEATBELT
All seating positions in this vehicle have seat belts. All
occupants of the vehicle should properly wear their seatbelt.
The seatbelt system consists of a buckle, shoulder loop, lap
belt, and retractor.
A seatbelt warning light and chime for the
driver seat.
Crash sensors and monitoring system
with readiness indicator.
1.
3.
PROPER SEAT BELT FIT
Always drive and ride with your seat
back upright, with the shoulder belt snug and
across the torso, and the lap belt snug and low
across the hips, and not across the abdomen.
NOTE: The seat belts installed in the C250 do not have
pretensioners or an automatic locking mode.
Proper location
of shoulder belt:
Belt must be centered
on your shoulder and
chest, away from your
face and neck.
Incorrect Location:
Shoulder belt must not
rub against face or neck.
Move seat belt height
adjuster down to adjust.
Incorrect Location:
Shoulder belt must not
hang o󰀨 shoulder. Move
seat belt height adjuster
up to adjust.
Page 17
2.
ADJUSTING THE SEAT BELT HEIGHT
Position the seatbelt height adjuster so
that the seatbelt rests across the middle of your shoulder.
Failure to adjust the seatbelt correctly could reduce its
e󰀨ectiveness and increase the risk of injury in a crash.
Adding too much slack to the seat belt
will reduce the seat belt’s e󰀨ectiveness during a crash,
and can result in injury or death to occupant.
Note: Before adjusting seat belt height, adjust the seat to the
proper position.
1. Pinch top and bottom levers together as you move the
shoulder loop to the correct height.
2. Move shoulder loop until it clicks into a locked position.
3. Gently tug on the shoulder belt to make sure it is locked.
ADJUSTING THE SEAT BELT LENGTH
To lengthen belt - Pull some seatbelt
webbing out of the seat belt retractor. Turn
the adjustable latch at right angle to the
webbing and pull away from the latch using
the lower webbing strap.
Top Lever
Bottom Lever
Shoulder Loop
Web Guide
Seat Belt
Height Adjuster
Shoulder Loop
Web Guide
To shorten belt - Pull the top webbing strap
directly away from the adjustable latch.
1.
2.
Page 18
Seat Belt
Retractor
SEAT BELT RETRACTOR LOCK-UP
The seat belt retractor locks only if there is a sudden stop or a
crash. If the retractor becomes locked up, it can be unlocked by:
1. Firmly grasp the web close to the retractor.
2. Pull web tight onto the spool, tight enough to allow web to
retract back into the retractor.
3. When released, this should unlock the retractor.
C250 CAB FEATURES