Morgan Olson C250 - Keyless Operation

Page 27
Page 26
Push the lever up or down to switch the turn signal
lights on. Set the lever to the middle position to
switch the turn signal lamps o󰀨.
The hazard asher button is on the instrument
panel (see page 3 for the location of the button).
Press the button to switch the hazard ashers on if your
vehicle is creating a safety hazard for other road users.
When you switch the hazard ashers on, all front and rear
direction indicators ash.
Note: The hazard ashers operate when the ignition is in
any position, or if the key is not in the ignition. The battery
loses charge and could have insu󰀩cient power to restart
your vehicle.
Press the button again to switch them o󰀨.
SWITCHING THE TURN SIGNAL LIGHTS
ON AND OFF
REAR TAIL LIGHTS
Top Brake Light - On at all times while the vehicle is switched
on. Lights brighten when the brakes are applied.
Auxiliary Flasher Light - Controlled using the instrument
panel button pad. A light on the button pad will indicate if the
auxiliary asher light is on. See page 5 for the button location.
Turn Signal and Hazard Lights - A dash panel
indicator ashes when you switch the turn signal lights
or the hazard lights on.
Brake and Tail Lights - On at all times while the vehicle is
switched on. Lights brighten when the brakes are applied.
Reverse Lights - On when the vehicle is in reverse (R).
SWITCHING THE HAZARD FLASHERS
ON AND OFF
Top Brake Light
Auxiliary Flasher Lights
Turn Signal and Hazard Lights
Brake and Tail Lights
Reverse Lights
Page 23 Page 24
KEYLESS ENTRY
Keyless Operation
Location
Single
Press
Unlock the curbside cab door
Double
Press
Unlock curbside roll-up door
and rear roll-up door
Press &
Hold
Unlock roadside roll-up door
and roadside cab door
The cab and cargo doors are controlled by a remote
control keyless entry system fob. Mechanical keys are also
provided for manual unlocking.
To operate the keyless entry system, press the button in the
center of the remote control fob with either a single press,
double press, or press & hold, depending on which door you
want to open.
The vehicle ignition is controlled through a proximity-based
remote control fob. The fob must be in the cab of the vehicle to
start the engine. To start the engine, press the brake pedal while
pressing the engine start button. To shut o󰀨 the engine, put the
gear shift into park (P), then press the engine start button.
KEYLESS IGNITION
The vehicle will begin an auto-shutdown sequence if the
remote control key fob is moved 15 feet from the vehicle while
the gear shift is in park (P). After a brief timer, the engine will
turn o󰀨 automatically. The cab doors’ automatic lock are
controlled separately after the cab doors are closed.
WALKAWAY SHUTDOWN FEATURE
The cab doors automatically lock after being
closed. Keep the remote control key fob with you at all times to
prevent locking yourself out of the vehicle. The cargo roll-up doors
automatically lock 10 seconds after an unlock signal. If the key fob
is detected in the cab while the curbside cab door is closed, the
vehicle will not auto lock after door closure.
All vehicle doors have a mechanical key for manual unlocking.
A
B
C
The curbside cab door will automatically unlock as the driver
is returning to the vehicle and approaches the detection zone
outside the curbside cab door.
PROXIMITY UNLOCK
A B
B
C C
C250 KEYLESS OPERATION