EasyManua.ls Logo

Morgan Olson C250 - Page 20

Morgan Olson C250
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 39
Page 38 Page 35
Maintenance Intervals
Mileage Interval Operations
every
5,000miles
Rotate the tires, inspect tire wear and measure tread depth
Change oil and lter: Gas engine; Up to 6.0 quarts of oil
every
30,000miles
Replace engine air lter(s).
every
100,000miles
Replace spark plugs.
every
150,000miles
Change front axle uid.
Replace accessory drive belt(s)
if not replaced within the last 100000 miles (160000 km).
Replace engine air lter(s).
Change rear axle uid.
Change transfer case uid, if equipped.
Change automatic transmission uid and lter.
Maintenance
INTERIOR & EXTERIOR LIGHT BULBS
The lighting components on the C250 are altered from
the Ford F150. Refer to Morgan Olson parts manual
for lighting component part numbers and descriptions.
SEAT BELT SYSTEM
AND TETHER MAINTENANCE
Any seat belt system that shows cuts, fraying, extreme, or
unusual wear, signicant discolorations due to ultraviolet
exposure, dusty-dirty conditions, abrasion to the seat belt
webbing, or damage to the buckle, latch plate, retractor,
hardware or any other obvious problem must be replaced
immediately, regardless of mileage.
We recommend that all seatbelt assemblies in use in vehicles
involved in a crash be replaced. However, if the crash was
minor and an authorized dealer nds that the belts do not
show damage and continue to operate properly, they do not
need to be replaced. Seatbelt assemblies not in use during a
crash should also be checked and replaced if either damage or
improper operation is noted.
CLEANING OF SEAT BELT FABRIC
Sponge the seat belt clean with mild soap and water.
Do not use bleach, dye, or household detergents.
REPLACING THE FRONT WIPER BLADES
1. Pull the wiper blade and arm away from the glass.
2. Lift the wiper blade primary locking clip.
5. To install, reverse the removal procedure.
Note: Make sure that the wiper blade locks into place.
3.
4.
3. Press the wiper blade secondary locking clip.
4. Remove the wiper blade.
Note: Make sure that the wiper arm does not spring
back against the glass when the wiper blade is not
attached.
A Morgan Olson 28” wiper blade (part # 49013555) is
used in your vehicle.
2.
Page 36
C250 MAINTENANCE