Page 2
CREASING
INDEX
THE STACKER ASSEMBLY
Setting the Height Adjustable Stacker unit 28
Setting the Optional Stacker unit 30
PERFORATING
Equipment, spares 31
Setting the perforating blade position 32
THE BLADE ASSEMBLY
Setting the blade pressure 34
REPLACING CREASING BLADE SETS
Installing crease blade sets 35
Spares 37
CROSS PERFORATING KIT 38
TROUBLE SHOOTING 39
DISPATCH KIT 47
ACCESSORIES & OPTIONS 48
RECOMMENDED SPARES 49
FUSE POSITIONS AND RATINGS 51
PRODUCT RECYCLING & DISPOSAL 52
INTRODUCTION
The Morgana AutoCreaser Pro 33A PAGE 3
SAFETY Do’s & Don’ts 4
THE AUTOCREASER PRO 33A
Labeled Picture 6
THE CONTROLS
The switch panel 7
Features on the switch panel 7
QUICK START GUIDE 8
SCREEN CALIBRATION 19
OPERATING THE MACHINE
Setting the machine 20
Setting up a job 24
Loading & saving 25
Paper jamming 27
Page 3
SYSTEM
INTRODUCTION
AutoCreaser Pro 33A
AutoCreaser Pro 33A
The Morgana AutoCreaser Pro 33A is a fully automatic suction feeding
creasing system designed for use with both conventional litho and digital
printers.
The feed on the AutoCreaser Pro 33A can also be manually operated for use
with heavy stock, very small or very large sheets, embossed or even irregular
sheets.
The crease is programmed from the leading edge of the sheet using the
controls on the front panel.
The blade and anvil are mechanically controlled over their entire length
and can be adjusted to accommodate various weights of media.
IMPORTANT
The operating environment should be controlled to a temperature between
16° C and 27° C Maximum.
Specification
Feeding System ................................................Bottom suction feed
Max. Sheet Size ................................................900mm x 330mm (27.5” x 12.6”)
Min. Sheet Size (in automatic mode)................. 210mm x 140mm (8.5” x 5.5”)
Max. Paper Thickness .......................................0.4mm (varies according to hardness,
type of fold, and substrate)
Max. No. Creases per Sheet ............................ 16
Min. Distance Between Creases ....................... 0.1mm
Max. No. Stored Programes ............................. Unlimited
Min. Crease Distance from Leading Edge ........ 2.5mm
Min. Crease Distance from Tail Edge ................35mm
In Hand Feed Mode up to 2499.9mm to Last Crease can be Programmed.
Speed per Hour (A4 in half)...............................8500
Speed per Hour (A5 in half)...............................11000
Dimensions ....................................................... L: 1450mm H: 1224mm W: 522mm
L: (57”) H: (48.2”) W: (20.5”)
Weight ............................................................... 121Kgs (+50Kgs packing)
Power Requirement .......................................... 1 phase 230v 50Hz
1 phase 220v 60Hz
Sound Power Level ........................... 78.0 decibels
*As part of our continued product improvement plan, specifications and information
published in this manual are subject to change without notice.
All specifications are dependant on application, type of stock, temperature, RH and print
engine used.
Specifications quoted were measured on uncoated and unprinted stock. E & OE.
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
To Next Page
Loading...
