Morgana DigiCreaser - Control Panel Error Messages; Routine Maintenance Procedures

Page23SYSTEM
Controlpanelreads
• Overlap-ProbableCause-DoubleSheet
Ifthemachineis‘cuttingout’andthecontrolpanelreads Overlap-ProbableCause
-DoubleSheet checkthatthemachineisnotfeedingmultiplesheets.
•
BladeNotHome
IfatanytimeduringthecreasingprocessthecontrolpanelreadsitBladeNotHome
isindicatingthatthelowerblade/anvilhasnotmadecontactwiththeHOMEswitchie.
bladestillintopposition.Switchthemachineoffandremovethebladesetandensure
thattheareaisfreefromobstructions.Returnthebladesettothecreasingunit
andswitchthemachineon.Operatethemachineinthenormalsequence,ifthe
displaycontinuestoreaditisadvisedtocontactaServiceEngineerBladeNotHome
immediately.
•
ThePaperPathisnotclear
IfbeforeoperatingthemachinethedisplayreadsthisThePaperPathisnotclear
indicatesthatthereisanobstructionbetweentheuppersensorassemblyandthe
paperguidesensor(asshowninthephotographonpage22).Ifthereisnoobvious
obstructioninthepaperpath,switchthemachineoffandrepeatthesameprocedureas
explainedabove.
TroubleShooting
RecommendedweeklyOperatormaintenance
• Cleanallsensors
• Cleaninfeedrollersandoutputdrivehubsusingthecleaningkitprovided
(Cleaningkitpartnumber-90-018)
• Removeandcleanthebladeassembly
• Withthebladeassemblyremoved,cleantheslotsandsurroundingarea
withinthecreasingunit.
TechnicianMaintenance
Itisrecommendedthatyourmachineisfullyservicedatleast
onceeverysixmonthsbyafactorytrainedServiceEngineer.
DigiCreaser