Quick start
1 Assemble the desired accessories as
shown on page 5.
2 Unwind the cable to it’s full length and plug
in to the mains supply.
3 Switch on by pressing the on/off power
switch.
Accessories
1 Fit the hose to the cleaner by first inserting
the hose adapter to the hose inlet.
Carry strap
Attach the hose to the hose adapter. A
Your vacuum cleaner comes with a carry strap
for added convienience.
The carry strap can be clipped on the two
hooks one at rear of the handle and the
other in front of the on/off switch.
Floor Nozzle
The floor nozzle adjusts to suit either carpet
or hard floor.D
2 The brush nozzle and crevice nozzle
Press down on the symbol for hard floors or
can be fitted directly into the hose inlet.
press down on the symbol to retract the
without the need for hose adapter. B
brushes for use on the carpet.
Turbo Nozzle (pets models only)
The turbo nozzle is ideal for use on carpets or
upholstery to remove stubborn pet hair.
Attach to the turbo nozzle directly to the hose
To store the brush nozzle and crevice
handle to remove stuborn pet hairs from
nozzle, insert brush nozzle vertically into
upholstery or small areas of carpet. (Turbo
clip then slide crevice nozzle horizontaly
nozzle is designed for small areas only for
until it clips into place. C
example pet beds and chairs)
3 All the other accessories attach to the
hose. The extension tubes can be
WARNING Do not attach the turbo nozzle
attached to the hose using the hose handle
to the extension tubes.
for floor cleaning or extra reach.
4
9 3
12 10
18
11
2
19
20
17
To Next Page
Loading...
