•
Technical Data
Power Supply : AC 230V 50Hz
Wattage : 800W
Always disconnect the cleaner from the
Using the blower function
mains when checking or replacing the
filters.
1 Remove the exhaust filter cover and
foam exhaust filter
• Always make sure the filters are fitted
correctly before use. Failure to do so may
2 Push and twist clockwise P the blower
result in damage to your product.
connector into the back of the cleaner
to lock into place.
Pre Motor Filter
3 Attach the hose to the correct end of the
blower connector .
The pre-motor filter can be found by
4 The blower function can be used for a
opening the dust compartment using the
variety of uses including blowing dust from
dust compartment release button
delicate surfaces and also drying pet fur.
Remove pleated hepa filter and mesh filter.
If using to dry pet fur:
Remove the pre-motor foam filter from its
• Never use the product in a wet
securing tabs and clean or replace.
environment.
Replace the foam filter over the small tabs
• Do not use if the animal is frightened
making sure it’s located correctly. N
or distressed.
• Never leave the product alone with the
Exhaust Filter O
animal. Never allow the animal to chew
the product.
The exhaust-filter must be cleaned
regularly to remove the fine dust particles
collected. This can be done by shaking it.
The exhaust filter is located behind the
exhaust filter covers . To remove, push
down on the tab and remove the cover. Pull
out the foam filter & clean or replace.
25
4
6
22
23
25
25
26
5
26
5
26
13
8
13
7
To Next Page
Loading...
