5
o
Symbol (120°C Max) Cool (160°C Max) Warm (210°C Max) Hot MAX setting
Control dial positions Do not iron
• •• •••
Fabric Nylon, Acetates,
synthetic fabrics
Wool, Polyester
mixtures
Cotton, Linen Rayon,
Rayon mixtures
Ironing Iron on wrong side, if
moisture required, use
damp cloth
(not Acetate)
Fabrics requiring
this setting usually
require steam
pressing.
Steam level setting
(see step 3 of ‘Using
the iron for steam
ironing’)
No steam
(see ‘Dry ironing’)
Low Medium / High High
With water in tank
Dry and spray
Steam/spray/shot of steam
Without water in tank Dry ironing
Temperature guide
Heat setting markings on the temperature dial of all Morphy Richards irons match those of the International Textile Care Labelling Code
Before use
Remove any protective cover from the soleplate (8).
Using the iron for steam ironing
1
Make sure the iron is not plugged in. Set the variable steam
switch (1) to
‘’
. Fill the water tank (11) via the filling hole (6).
IN HARD WATER AREAS, WE RECOMMEND A MIX OF 50%
TAP WATER AND 50% DISTILLED OR DEMINERALISED
WATER.
Never use battery topping up fluid or water containing any
substances like starch, sugar, fragrant additives or defrosted
water from a refrigerator.
2
Plug in the iron and switch on at the mains.
Set the temperature dial (9) to the temperature required (see
‘Temperature Guide’). Begin with cool fabrics and work up to
higher settings. An iron heats up quicker than it cools down so
you will save time and energy.
Your iron is fitted with a temperature indicator light (10) which will
switch on and off whilst you are ironing.
The temperature indicator light will illuminate until the required
temperature is reached, then it will turn off.
3
Vary the steam output using the variable steam switch (1).
Only use the steam facility onheavy fabrics (midway between 2
and 3-dot, to MAX).
4
For stubborn creases, use the water spray button (2). You may
need to press this a few times to prime the pump.
5
Steam boost
Press (3) for an extra steam boost for stubborn creases / heavy
fabrics.
NOTE: If you need to use the steam boost whilst dry ironing,
check the temperature dial (9) is set within the steam range.
NOTE: For optimum steam quality, do not operate the shot more
than three times in succession.
Features of your iron
Dry ironing
Your iron can be used for dry ironing. Set the variable steam
switch (1 to
‘ ’
and set the temperature dial (8) as desired
(‘Temperature Guide’).
You won’t need water in the tank unless using the water spray or
steam boost features.
6
Vertical steam
Vertical steam is useful for removing creases from hanging
To Next Page
Loading...
