Morphy Richards Total Control - Pre-Clean Function Guide

13
How To Use Pre-Clean Function
1
Ensure the Total Control Soup Maker is
unplugged from the mains. Remove the Lid
(4), be careful not to touch the Serrator Blade
(8). WARNING: Sharp Blade.
2
Pour in 800ml of water into the Removable
Vessel (7) and add a small amount of washing
up liquid.
4
S
TAR T
STOP
PORTIONMODE
PM
Press the Mode Button (22) until the
Pre-Clean Function Indicator (20) is
highlighted.
5
START
STOP
PORTIONMODE
PM
Press the Start/Stop Button (23) and the
processing time will count down on the
LED screen (21). The Pre-Clean program will
run for 4 minutes.
3
Place the Lid (4) back onto the Jug Body (10)
ensuring it is securely in place. Plug the Total
Control Soup Maker into the mains.
6
When the Pre-Clean cycle has finished
ensure the Total Control Soup Maker is
unplugged from the mains. Remove the Lid
(4), be careful not to touch the Serrator Blade
(8). WARNING: Sharp Blade.
NOTE: The Pre-Clean function will clean the base only. Additional cleaning is required for the
Removable Vessel
(7) and Lid (4). See A Dream to Clean on page 32. Rinse out your Soup
Maker with water until the water is clear of soap bubbles.
WARNING: Take care as the Removable Vessel
(7) will be hot after the Pre-Clean cycle.
501020 Rev 1.qxp_Layout 1 26/08/2016 09:54 Page 13