6
Emptying and storing
When you have finished ironing, unplug and
e
mpty all water from your iron and set the steam
switch at the ‘O’ position. When cool, store the
i
ron on its heel with the cord wrapped loosely
a
round the heel.
NOTE: Please see point 4 of ‘Exclusions’ on page 8.
Cleaning the soleplate
To clean a coated soleplate
Do not use scouring powder or solution as this
could cause damage to the coating.
If any man-made fibres fuse to the soleplate (8),
set the iron at the MAX position and pass it over
a clean piece of cotton to draw the deposit off
the surface.
To clean the exterior
Allow the unit to cool and wipe over with a damp
cloth and mild detergent, then wipe dry.
Self clean
Y
our iron has a built in self clean system
designed to keep the water valve, steam
chamber and steam vents clear of lint and
loose mineral deposits.
1 Half fill the iron with water.
2 Place the iron on its heel
(11)
.
3 Move the variable steam switch
(1)
to the ‘O’
position.
4 Connect to a mains supply outlet.
5 S
et the temperature to ‘MAX’. See step 2 of
‘Using your iron’ on page 4.
6
Leave the iron switched on, rested on its heel (11)
u
ntil the temperature reaches maximum, this is
achieved when the indicator light
stops flashing
a
nd remains constantly on
.
WARNING: Keep hands and body away from
the hot soleplate.
7 Disconnect the iron from the mains supply outlet.
8 Whilst the iron is still very hot, hold the iron
horizontally over a sink.
CAUTION: The soleplate will still be hot, so
ensure the power cord and plug are kept away
from it and the sink.
9
Push the variable steam switch
(1)
fully to the left
and hold in the self clean position
(5)
.
WARNING: Steam and boiling hot water will
drain from the holes in the soleplate. Keep
hands and body away from the hot water. This
washes away the scale and minerals that have
built up inside the steam chamber.
10
Whilst still holding the variable steam switch
(1)
in the self clean position, gently move the iron
back and forth until the water tank is empty.
11
When cleaning is complete, move the variable
steam switch back to the ‘O’ position.
12
Rest your steam iron back on its heel and allow
to fully cool down.
13
Wipe the soleplate
(8)
with a cold, damp cloth.
After this cleaning operation, empty out any
remaining water.
IMPORTANT: Do not attempt to descale the
soleplate with descaling products.
Maintaining your iron
To Next Page
Loading...
