EasyManua.ls Logo

Morso 1410 Squirrel - Page 13

Morso 1410 Squirrel
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
Do not for any reason attempt to increase the ring of your heater by altering the air control
adjustment range outlined in these directions.
Warning: Fireplace stoves must never be left unattended with doors open.
If the door is left partly open, gas and ame may be drawn out of the replace stove open-
ing, creating risks from both re and smoke. We recommend that you t a smoke detector
in the room where the stove is installed.
DO NOT OVERFIRE THIS HEATER. Overring may cause a house re, or can result in per-
manent damage to the stove. If any part of the stove glows, you are overring.
5. When ready to reload, use a poker to spread the ember
across the rebox oor, bringing plenty towards the front
of the stove.
6. Lay three pieces of wood (see dimensions above) onto
the embers. Leave half an inch (1 cm) or more between
each piece. Place the ends of your logs towards the open-
ing, but not too close to the front.
7. Close the door. Leave the primary air supply fully open.
8. After a few minutes, and adjust the primary air supply
to suit your heating requirements.
9. Anticipate each refueling, remembering to add a modest
layer of wood while there are still plenty of live embers, Re-
peat steps 5-8.

Related product manuals