12
Sprog
5. If the condition in step 4 is met, place max. 2 pieces of
wood with a total weight of 1.5-2 kg and a length of 25-
30 cm over the embers in a single layer, with a distance
of approximately 1 cm.
6. Open the air supply to maximum, and close the door.
The fresh wood will be lit within 1-3 minutes.
If it does not light, open the door slightly to allow in en-
ough air to ignite the wood.
Close the door again once the wood has caught.
7. Reduce the amount of combustion air to the desired
position, and the optimal combustion will continue.
Make sure that there is always enough air (oxygen) to
maintain clear, lasting ames when, and after, reducing
the amount of combustion air.
Make sure that there is always enough air (oxygen)
to maintain clear, lasting ames when, and after, re-
ducing the amount of combustion air.
The stoking interval is between 45-75 minutes.
8. Once the re has been reduced to a thick layer of em-
bers, a new portion of wood can be added by repea-
ting steps 5 & 7.
Important!
It is important that the fresh quantity of wood
starts to burn quickly. To ensure the fuel lights
quickly, open the combustion air to max. or leave
the door ajar to allow in the amount of air needed
to light the wood.
If, however, the wood only smoulders, there will
be a strong build-up of smoke, which at worst can
cause an explosive ignition of the ue gases with
the risk of material damage and personal injury.
To Next Page
Loading...
