SECTION 2
15
Setting the Number of Patient Cable Lead Wires
CABLE is used to set the number of lead wires for the patient cable.
From the CONFIGURE menu, use Down or Up/Right to scroll to CABLE. Press Enter to select. The CABLE
menu includes:
4 lead wire
5 lead wire
10 lead wire
Use Down or Up/Right to scroll to the desired option and press Enter. When finished, press Enter to exit the
CABLE menu.
NOTE: When a 4-wire or 5-wire cable is selected, only the limb leads (and a V label with the 5-wire
cable) will appear in LEAD CHECK, DISPLAY ECG, and lead fail messages.
Setting Language
LANGUAGE is used to select the language displayed in the main menu and all sub-menu options.
From the CONFIGURE menu, use Down or Up/Right to scroll to LANGUAGE. Press Enter to select. When
finished, press Enter to exit the LANGUAGE menu.
Viewing Software Version Number
VERSION displays the current software version installed in the X12+.
From the CONFIGURE menu, use Down or Up/Right to scroll to VERSION. Press Enter to select and view the
current software. When finished, press Enter to exit the VERSION menu.
Viewing Battery Voltage
BATTERY displays the voltage of the battery currently installed in the X12+.
From the CONFIGURE menu, use
Down or Up/Right to scroll to BATTERY. Press Enter to select and view the
current battery voltage. When finished, press Enter to exit the BATTERY menu.
To Next Page
Loading...