EAS15-806-GB.doc
EAS 15 - 806
REV.1-07/11
- Before doing any cleaning or maintenance, de-energise and switch off the machine it is connected to.
- De-energise and disconnect the equipment in the event of breakdown or malfunction. If any repairs is needed contact an Authorized Retailer only
and ask that only original spare parts are used. Failing to observe the above instructions may put the safety of the electric control board at risk
and the warranty will immediately decline.
- Make sure that earthing complies with the standards in force in the country in which the appliance is used.
- Check that the information on the control panel identification plate is compatible with appliance ratings such as voltage, current, frequency, etc.
- If the control panel can be locked, make sure that only authorised personnel can use the key to open the control panel.
- If the control panel is fitted with guards that need to be removed to wire up the control panel, make sure that they are refitted after the control panel
has been wired up. Make sure that the control panel is disconnected and locked out during these operations and that no parts carry residual current.
- Strictly follow the wiring diagram that accompanies the control panel.
- The manufacturer declines any responsibility in to following cases:
a) misuse of the machine or use by persons not trained for its operation.
b) incorrect installation.
c) serious lack of due maintenance.
d) unauthorized modifications or servicing.
e) use of non-original or non-specific spare parts for the model.
f) total or partial failure to follow the instruction.
g) Exceptional events ect.
The instruction manual can never substitute a sufficiently experienced user.
Warning: This booklet is not binding. The producer reserves the right, without prejudice to the essential features of the model herein
described and illustrated, to make improvements and modifications to parts and accessories without moreover undertaking to update this
manual in time.
1.3 - Symbols in the manual
The symbols contained in this manual have the purpose of drawing the user’s attention in order to prevent trouble or danger both for persons and
objects or the equipment.
These symbols moreover have the purpose of drawing your attention in order to indicate correct use and obtain good operation from your electric panel.
1.4 - Important tips
User tips on safety:
N.B. The information contained in this manual may be changed without notice.
Any damage caused in relation to the use of these instructions shall not be considered since they are only guidelines.
We remind you that failure to observe the instructions we give could cause injury or damage.
It is anyhow understood that current local regulations and/or laws must be observed.
1.5 - Cautions
Hazardous situations - safety for persons and objects.
USE ONLY WITH SAFE INSTALLATIONS
It is prohibited to fail to comply with, take away or put out of service the instructions, safety and supervision functions.
USE ONLY IN PERFECT TECHNICAL CONDITIONS
The electric panels must be used in perfect technical conditions. Any defects that may alter safety must immediately be eliminated.
Never install the electric panels close to sources of heat, in areas where there is a risk of explosion or fire hazard.
Where possible, repair the electric panels in a dry place far from water, protecting them against moisture.
1.6 - Noise
This appliance is in conformity with the provisions of EEC Directive 86/594 since the level of sound pressure is “irrelevant” (it is not perceptible by the
hearing of a human being) since its operation is given by the flow of energy passing through the control components and by the management of the
electric control panel.
To Next Page
Loading...
Need help?
General