Stopping the engine MAGIC WELD
M
27
© MOSA 1.0-05/04
21/05/04 22243-GB
Before stopping the engine it is compulsory:
-Disconnect or close any power load connected
to the system’s auxiliary generation.
-Interrupt welding.
To shut down the motor:
o shut down the motor in case of emergency,
turn the motor switch (28) to OFF.
In normal conditions, wait for the engine to
reach minimum speed automatically 6/7
seconds after the load has been excluded.
Turn the engine in these conditions for a few
minutes so that it can cool down and then turn
the engine switch (28) to OFF.
Turn the fuel valve to the OFF position.
ENGINE SWITCH
FUEL VALVE
To Next Page
Loading...
