T (450) 588-6555 - 1 866 650-6555 F (450) 588-0200
info@motioncomposites.com
22
If you ignore these Warnings or fail to inspect or maintain your
wheelchair as directed in the manual , you may fall, tip over or lose
control of the wheelchair and seriously injure yourself or others or
damage the wheelchair.
13. Maintenance and Safety
Inspection Checklist
At every use
Make sure wheelchair rolls easily and straight.
Check for vibrations, noise or any deviation from normal
functioning.
Ensure wheel locks are working properly.
Ensure that front stem is perpendicular to floor.
Visually inspect tires (front & rear) for debris, low pressure, flat
spots or wear.
Make sure anti-tipper tubes are locked in place (if equipped).
Visually inspect fabric for protruding metal, rips or tears.
Ensure that hand grips are not loose (if equipped).
Check hand rims for rough edges and make sure they are free
from grease or other contaminants.
Checks for component interference.
Check for irregular noise and rattles.
Weekly
Check tire pressure with a tire gauge
Check seat tension.
Monthly
Check wheel alignment.
Check for free running of fork bearings.
Yearly
Have a complete inspection
performed by a qualified technician.
Tire pressure could be adjusted by the owner or an
assistant with the proper tools. If any part appears not
to work properly after inspection, the wheelchair should
be immediately sent for repair to a qualified technician.
Motion Composites
519 J-Oswald-Forest Suite 101, St-Roch-de-l’Achigan
Quebec, Canada, J0K 3H0
Phone: 1-866-650-6555
Fax: (450) 588-0200
support@motioncomposites.com
www.motioncomposites.com
14. DECLARATION OF
CONFORMITY
Name and Address of Product Owner
Motion Composites
519 J-Oswald-Forest Suite 101, St-Roch-de-l’Achigan
Quebec, Canada, J0K 3H0
Phone: 1-866-650-6555
Fax: (450) 588-0200
support@motioncomposites.com
www.motioncomposites.com
Authorized representative
Advena Ltd.
Pure Offices, Plato Close, Warwick
CV34 6WE, United Kingdom
We hereby declare that the below mentioned devices
have been classified according to the classification
rules and conform to the Essential Principles of Safety
and Performance as laid out in the Health Products
(Medical Devices) Regulations 93/42/CEE.
Medical Device(s):
Helio C2 manual wheelchair
Manufacturing site:
Motion Composites
519 J-Oswald-Forest Suite 101, St-Roch-de-l’Achigan
Quebec, Canada, J0K 3H0
Risk classification:
Class 1 Medical Device (per 93/42/CEE).
Standards applied:
• NF EN ISO 7176-1:
Wheelchairs, part 1: Determination of static ability.
• NF EN ISO 7176-5:
Wheelchairs, part 5: Determination of dimensions,
mass and manoeuvring space.
• NF EN ISO 7176-8:
Wheelchairs, part 8: Requirements and test methods
for static, impact and fatigue strengths.
• NF EN ISO 7176-11:
Wheelchairs, part 11: Test Dummies.
• NF EN ISO 7176-15:
Wheelchairs, part 15: Requirements for information
disclosure, documentation and labeling.
This declaration of conformity is valid from 2013/01/16.
To Next Page
Loading...
Need help?
General
