Motorola solutions AP-0622 - External Antenna Model Wall Mount Instructions; Wall Mount Hardware; Wall Mount Procedure - New Installation

12 AP-0622 Access Point
2.6 External Antenna Model Wall Mount Instructions
A wall mount deployment requires hanging the AP-0622 access point along its width or length using the pair of
slots on the bottom of the unit. The AP-0622 can be mounted on to any plaster, wood or cement wall surface using
the provided wall anchors.
2.6.1 Wall Mount Hardware
• Two customer provided wide-shoulder Phillips pan head self-tapping screws (M3.5 x 0.6 x 20 mm)
• Two wall anchors (customer supplied)
• Security cable (optional)
2.6.2 Wall Mount Procedure - New Installation
This section describes a new AP-0622 installation with no previous access point existing on the intended wall
surface.
NOTE The following screws are recommended: (ANSI Standard) #6-18 X
0.875in. Type A or AB Self-Tapping Screw, or (ANSI Standard Metric)
M3.5 X 0.6 X 20mm Type D Self-Tapping Screw.