4.4
Using the Carry Holder
Procedure:
1 To insert the radio into the carry holder, perform the following actions:
a Position the radio within the carry holder with the main speaker facing outward.
b Slide the radio down into the carry holder until it clicks in place.
2 To remove the radio from the carry holder, perform the following actions:
a Place the tip of your fingers on the ledge of the carry holder.
b Push the bottom of the radio until it is released from the carry holder.
4.5
Charging the Radio
Prerequisites:
WARNING:
To avoid possible explosion:
• Do not replace the battery in any area labeled Hazardous Atmosphere.
• Do not discard batteries in a fire.
Procedure:
1 Turn off the radio while charging in a single or multi-unit charger.
2 Place the radio in a Motorola Solutions-approved charger.
NOTICE: If the radio must remain powered on in the multi-unit charger, LMR PTT is not
allowed as possible degradation in performance may occur.
4.6
Turning the Radio On and Off
Turning On the Radio
Prerequisites: Ensure that the battery is fully charged before the first use.
Procedure:
• To turn on the radio, rotate the On/Off/Volume Control Knob clockwise until you hear a click.
MN005642A01-AG
Chapter 4: Getting Started
18
To Next Page
Loading...
Need help?
General
