Motorola AP-7131 - Wi-Fi Protected Access (WPA) Using TKIP Encryption; WPA2-CCMP (802.11 i) Encryption

Basic AP-7131 Configuration
21
2.5.3 Single Radio 5 Ghz AP-7131 LEDs
The single 5 Ghz radio model AP-7131 has the following unique LED behavior:
2.5.4 Rear AP-7131 LED
The LED on the rear (bottom) of the AP-7131 is viewed using a single (customer installed) extended
light pipe, adjusted as required to suit above the ceiling installations. A LED displayed using the light
pipe has the following display and functionality:
3 Basic AP-7131 Configuration
For the basic setup described in this guide, the Java-based Web UI will be used to configure the
AP-7131. To access the AP-7131 via the GE1/POE port, the GE1/POE port default setting is DHCP
client. For this example, the AP-7131’s WAN interface will be used to connect to the access point.
LED 1 LED 2 LED 3 LED 4 - 5 GHz LED 5 - 2.4 GHz LED 6
Blinking Red
indicates
booting. Solid
Red defines a
failure
condition.
White defines
normal
operation
Green defines
normal GE1
operation.
Yellow defines
a collision
Green defines
normal GE2
operation.
Yellow defines
a collision
Amber defines
5 GHz radio as
configured.
When
functioning as a
sensor, LED
alternates
between
Amber and
Yellow.
The blink
interval is 0.5
seconds.
Off Not Used
LED 7
Blinking Red indicates booting.
Solid Red defines a failure condition.
White defines normal operation.