Installation Guide 29
reserved for standard network services. This is a required parameter.
• Default Gateway - Define a default gateway address for use with the default gateway. This is a
required parameter.
• DNS Forwarding - Select this option to allow a DNS server to translate domain names into IP
addresses. If this option is not selected, a primary and secondary DNS resource must be specified.
DNS forwarding is useful when a request for a domain name is made but the DNS server, responsible
for converting the name into its corresponding IP address, cannot locate the matching IP address.
• Primary DNS - Enter an IP Address for the main Domain Name Server providing DNS services for
the access point's LAN interface.
• Secondary DNS - Enter an IP Address for the backup Domain Name Server providing DNS services
for the access point's LAN interface
14. Select Next. The Initial AP Setup Wizard displays the WAN Configuration screen to set the access
point's WAN interface configuration.
15. Set the following DHCP and Static IP Address/Subnet information for the WAN interface:
• Use DHCP - Select the checkbox to enable an automatic network address configuration using the
access point’s DHCP server.
• Static IP Address/Subnet - Enter an IP Address/Subnet and gateway for the access point's WAN
interface. These are required fields
• The port connected to the WAN - Select the port used as the physical access point connection to the
To Next Page
Loading...
