Motorola APX 1000 Series - Mode Select Feature; Saving a Zone and a Channel to a Softkey

a) If channel is set as the primary mode, turn the
MFK until the display shows the desired
channel.
If channel is not set as the primary mode, press
the MFK once and repeat this step.
b) Press the PTT button to begin transmitting on
the displayed channel.
•
Select a channel via the radio menu Chan:
a)
or to Chan.
b) Press the Menu Select button directly below
Chan.
c) or to the required channel.
d) Press the Menu Select button directly below
Sel to confirm the selected channel.
e) Press the PTT button to transmit on the
displayed zone channel.
•
Select a channel via the radio menu Channel Up
or Channel Down:
a)
or to ChUp or ChDn.
b) Press the Menu Select button directly below
ChUp or ChDn.
Positions of
ChUp and ChDn on the display may
differ each time you release the Menu Select
button. Read carefully before you press.
c) Press the PTT button to transmit on the
displayed zone and channel.
Mode Select Feature
Mode Select allows a long press to save the current
zone and channel of your radio to a programmable
button, keypad button, or a softkey; then once
programmed, the short-press of that button or softkey
changes the transmission to the saved zone and
channel.
There are two methods to save the selected zone and
channel:
• Softkeys
• Programmable buttons
Note: Your radio must be preprogrammed to allow
you to use this feature.
Saving a Zone and a Channel to a Softkey
Five softkeys are available for you to save the
frequently used zone and channel.
General Radio Operation
46
English