Viewing the Current Site
Perform one of the following actions:
• Press the preprogrammed Site Displ/Srch
button.
•
or to RSSI and press the Menu Select
button directly below RSSI.
The display shows momentary the name of the
current site and its corresponding received signal
strength indicator (RSSI).
Changing the Current Site
Perform one of the following actions:
• Press and hold down the preprogrammed Site
Displ/Srch button.
• Press and hold down the Menu Select button
directly below RSSI.
You hear a tone and the display shows
momentary Scanning site.
When the radio finds a new site, it returns to the
Home screen.
Programming Over Project 25 (POP 25)
(ASTRO 25 and ASTRO Conventional)
This feature enables configuration data to be
upgraded to your radio over-the-air. This feature
retains full use of the radio during the configuration
data transfer without interrupting communication. The
upgrade pauses to give priorities to voice call, and
continues after the voice call ended.
Once a configuration upgrade is downloaded to your
radio, you can install new changes immediately or
delay changes to be installed on the radio when it is
being powered up.
Your radio can also be configured to allow you to
accept or reject an upgrade.
Note: This feature must be preprogrammed by a
qualified radio technician. Check with your dealer or
system administrator for more information.
Responding to the Notification of Upgrade
1
The display shows Upgrade?.
2 Perform one of the following actions:
92
English
To Next Page
Loading...
