Parameter Editing Keys Value
Busy LED ON/OFF
Low Batt
LED
ON/OFF
MPL Enable Disabled/Rx
/Tx/All
Scan List None/Scan
List 1, 2,
3,...
Zone Name The names must be configured in CPS.
Top Chan
Name
Top Zone
Name
Chan Name
NOTICE:
To edit Tx PL, Rx PL, Tx DPL, and Rx DPL, the PL Setting must be set to Disabled.
If PL setting is set to ALL, Rx or Tx, there is no Edit selection available to change the
codes for Tx PL, Rx PL, Tx DPL, or Rx DPL.
If PL setting is set to Rx, you can only edit Tx PL and Tx DPL codes.
If PL setting is set to Tx, you can only edit Rx PL and Rx DPL codes.
MN004863A01-AG
Chapter 6: Advanced Features
108
To Next Page
Loading...
